How to resolve LANWAN conflicts using a spare Ewon HMS

Natitf Config On Ewon. Ewon Cosy 131 WiFi Won't Connect Stuck on Wizard eWON Cosy eWON A Configuration Note IP WAN 192.168.120.xxx DHCP or given by the company Subnet Mask WAN (given by company LAN) DHCP or given by the company I cannot find the security settings that was mentioned under networking

Ewon's web interface: changing NatItf setting on Cosy; On Flexy, navigate to Setup → System → Communication →. In a typical Ewon Cosy installation, all communication through the Cosy occurs within an

eCatcher > VPN tunnel error> STATE 1645107440,GET_CONFIG Ewon

in S7-300/400 ethernet configuration set access via Router and Subnet mask to EWON ip address NatItf:3 • To set the "Wan Protection" level to "Discard all traffic excepted VPN and initiated traffic": WANItfProt:1 • To disable the IP forwarding to the WAN port: FwrdToWAN:0 You can also apply these settings using a put FTP to the eWON root parameters in the eWON A: WANPermCnx:1 FwrdToWAN:1 NatItf:2 - Note - With the example we gave, you would need to change these parameters in eWON A: EthIP:172.31.254.1 EthMask:255.255.255.252

Ewon Flexy Connectitude IIoT Platform™. in S7-300/400 ethernet configuration set access via Router and Subnet mask to EWON ip address Another use case is to use eWON as an Internet gateway

eCatcher > VPN tunnel error> STATE 1645107440,GET_CONFIG Ewon. By default EWON is configured to block internet access i.e eWON A Configuration Note IP WAN 192.168.120.xxx DHCP or given by the company Subnet Mask WAN (given by company LAN) DHCP or given by the company