Throttle Position Sensor (TPS) for Polaris Ranger Grandado
Polaris Tps. 0.87in Throttle Position Sensor TPS For Polaris Ranger Sportman 500 550 I ended up having to set the TPS while installed in order to get the correct readings to make it run right TPS Adjustment procedure Short Versionadjusting the idle voltage (1) Find the yellow wire leading to the TPS and carefully pierce the insulation with the positive lead of your multimeter (make sure that you seal that bare spot when finished)
Loosen the throttle cable all the way, you might even want to disconnect it from the throttle body. Connect a fully charged 12v battery to this and it will power up the ECM
TPS Adjustment procedure Short Versionadjusting the idle voltage (1) Find the yellow wire leading to the TPS and carefully pierce the insulation with the positive lead of your multimeter (make sure that you seal that bare spot when finished) I used sharpened paper clips to back-probe and a digital meter Polaris 2008 sportsman 800efi Manual Online: throttle position sensor test, Throttle Position Sensor Initialization
Throttle Position Sensor TPS For Polaris Sportsman 570 20142016, ACE. I used sharpened paper clips to back-probe and a digital meter Bottom line is that once removed or replaced its extremely difficult to set the TPS correctly without an accurate meter connected to a test harness to set the base voltage and the special tool to set the idle speed or without having it connected to a laptop with the Polaris software
New TPS Throttle Position Sensor For Polaris Sportsman 570 2014 2015. TPS Adjustment procedure 2005-2010 XPs: By: commanderjjones aka Jerry _____ TPS = Throttle Position Sensor: The TPS is located on the passenger side of the throttle body Now your ready to check your TPS settings Next step is to provide 12volts to the ECU connector in front of the clutch cover near the upper shock mount